3D Modelling, 3D Printing

Magnetic Leatherman Surge bit holder

May 8, 2022

I got tired of the Leatherman bits, and decided to design a suitable holder for standard sized bits.

Requires 8x 6mm wide and 3mm thick magnets.

Good fit on the side strap.

Not too much stickout on either end.

The bits are visible through the opening.

Good match with the bit extension.

It uses “standard” sized magnets for 3D models.

3D model.

previous

Mood-O-Meter

newer

WD40 can holder

Leave a Reply Cancel reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.

This website uses very few cookies, but cookies nevertheless. By continuing to use this site, you accept the use of cookies.