Silfer Works

OPUS KAAMOS

Water Spraying Teapot

As you might have already figured out, this is a kids’ toy and not an actual teapot. It uses the same design as the Babar – The water spouting elephant, but the teapot has much larger volume and also has some small teacups to go with it.

This is how it ended up looking.
And this is how it works. My younger daughter got camera shy, so my older son had to step in to demonstrate it.
On a transparent image of the 3d model, you can see how the water is forced through from the lowest point of the container. This is the reason why it sprays water when blown into.
The 3D model ended up looking very lifelike.
The inside of it.
It also prints very nicely.

Tags:

,

More projects:

Visual Portfolio, Posts & Image Gallery for WordPress
Bnitvfzrh7y81
3D Modelling
3D Printing

Magnetic Leatherman Surge bit holder

I got tired of the Leatherman bits, and decided to design a suitable holder for standard sized bits. Requires 8x 6mm wide and 3mm thick magnets. Good fit on the side strap. Not too much stickout on either end. The bits are visible through the opening. Good match with the…
2d2omina6ra91
3D Modelling
3D Printing

3D printed padlock

This was created for my kids to play with, but in reality it was more of a design challenge than anything else. The lock is “fully functional” in the sense that it can only be opened with the key that belongs to it. The only hardware you need is a…
8
Metalworking

Special sauna ladle

This was the first project with my TIG welder. I wanted to have a very specific ladle for my sauna, so I decided to make one myself. I find it difficult to get the water around the chimney in the sauna, so I made a ladle that can do that….

This website uses very few cookies, but cookies nevertheless. By continuing to use this site, you accept the use of cookies.